On 2/22/13 13:35 , SourceForge.net wrote: > You are probaly right even if with the scope it's not very clear. After > grounding everything, changing the power supply, i tried to find a software > improvement adding a timer but up to now it's not 100 % working. A g38 > choosen without error code was looking like an answer :o)
In halscope, try looking at the net (aka signal) connected to motion.probe-input, and trigger on a rising edge. Then trigger the probe with your finger, it should be obvious if it's bouncing or not. If the signal is bouncing, use a debounce(9) component between the input pin and the net (signal) that carries the probe bit to motion.probe-input. -- Sebastian Kuzminsky ------------------------------------------------------------------------------ Everyone hates slow websites. So do we. Make your web apps faster with AppDynamics Download AppDynamics Lite for free today: http://p.sf.net/sfu/appdyn_d2d_feb _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers
