Then why did i have to install the 2 files referenced to allow Linuxcnc to run i am NOT using Machinekit
Dave On 5 August 2014 13:58, Jeff Epler <[email protected]> wrote: > On Mon, Aug 04, 2014 at 07:05:21PM +0100, David Armstrong wrote: > > Guy's > > just for information , jeff's boot image as per the wiki > > http://article.gmane.org/gmane.linux.distributions.emc.user/52401 > > The LinuxCNC image you refer to is built by Chris Radek, not by any Jeff. > > > and found that > > > > /etc/security/limits.d/linuxcnc.conf > > /etc/udev/rules.d/50-LINUXCNC-shmdrv.rules > > > > were not included > > These may be files that are shipped by the MachineKit project. LinuxCNC > is not MachineKit and does not ship these files. "shmdrv" is > machinekit-specific, and in current versions of LinuxCNC we increase the > locked memory limit by appending lines to /etc/security/limits.conf; > this was done because at the time we added this, limits.d did not exist > yet. Patches to change our packaging to use limits.d instead would be > welcome. > > Jeff > > > ------------------------------------------------------------------------------ > Infragistics Professional > Build stunning WinForms apps today! > Reboot your WinForms applications with our WinForms controls. > Build a bridge from your legacy apps to the future. > > http://pubads.g.doubleclick.net/gampad/clk?id=153845071&iu=/4140/ostg.clktrk > _______________________________________________ > Emc-developers mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-developers > ------------------------------------------------------------------------------ Infragistics Professional Build stunning WinForms apps today! Reboot your WinForms applications with our WinForms controls. Build a bridge from your legacy apps to the future. http://pubads.g.doubleclick.net/gampad/clk?id=153845071&iu=/4140/ostg.clktrk _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
