Can you explain the steps that brought you to needing those 2 files? (I have been running the new livecd for the past couple weeks with both the 7i80, 5i20 and rtai/rt-preempt with no issues.)
sam On 8/5/2014 8:17 AM, David Armstrong wrote: > Then why did i have to install the 2 files referenced to allow Linuxcnc to > run > i am NOT using Machinekit > > Dave > > > On 5 August 2014 13:58, Jeff Epler <[email protected]> wrote: > >> On Mon, Aug 04, 2014 at 07:05:21PM +0100, David Armstrong wrote: >>> Guy's >>> just for information , jeff's boot image as per the wiki >>> http://article.gmane.org/gmane.linux.distributions.emc.user/52401 >> The LinuxCNC image you refer to is built by Chris Radek, not by any Jeff. >> >>> and found that >>> >>> /etc/security/limits.d/linuxcnc.conf >>> /etc/udev/rules.d/50-LINUXCNC-shmdrv.rules >>> >>> were not included >> These may be files that are shipped by the MachineKit project. LinuxCNC >> is not MachineKit and does not ship these files. "shmdrv" is >> machinekit-specific, and in current versions of LinuxCNC we increase the >> locked memory limit by appending lines to /etc/security/limits.conf; >> this was done because at the time we added this, limits.d did not exist >> yet. Patches to change our packaging to use limits.d instead would be >> welcome. >> >> Jeff >> >> >> ------------------------------------------------------------------------------ >> Infragistics Professional >> Build stunning WinForms apps today! >> Reboot your WinForms applications with our WinForms controls. >> Build a bridge from your legacy apps to the future. >> >> http://pubads.g.doubleclick.net/gampad/clk?id=153845071&iu=/4140/ostg.clktrk >> _______________________________________________ >> Emc-developers mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-developers >> > ------------------------------------------------------------------------------ > Infragistics Professional > Build stunning WinForms apps today! > Reboot your WinForms applications with our WinForms controls. > Build a bridge from your legacy apps to the future. > http://pubads.g.doubleclick.net/gampad/clk?id=153845071&iu=/4140/ostg.clktrk > _______________________________________________ > Emc-developers mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-developers > > ------------------------------------------------------------------------------ Infragistics Professional Build stunning WinForms apps today! Reboot your WinForms applications with our WinForms controls. Build a bridge from your legacy apps to the future. http://pubads.g.doubleclick.net/gampad/clk?id=153845071&iu=/4140/ostg.clktrk _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
