Hallo Len, if you hit the wrong command, that is your fault! Please be carfull!
But that behavior would not be changed if you also allow jogging in MDI mode and machine being idle. I have attached to my pendant a "dead Man Switch" so if that button is not pressed, no movement will ocure, but if I press that button and than also the "Set X" button, it will set my X axis to zero. So it can destroy the part if I use that button in a wrong situation. Norbert Am 16.01.2016 um 18:30 schrieb Len Shelton: > I think the issue is that selecting the MDI tab places it in auto mode. > I would agree that simply selecting that tab should not change modes, > but actually running an MDI command should. Its just as dangerous > allowing a double click from an MDI history to run that command. I have > double clicked the wrong command too many times. > > >Len > > > > On 1/16/2016 11:23 AM, Niemand Sonst wrote: >> I do not want to jog in Auto mode, but why not in MDI Mode? >> >> I do agree, that jogging during a machine movement is not a good idea. >> But in MDI MOde the machine is very often in the idle state and jogging >> should be allowed. >> >> There could be a status check for machine is idle to allow jogging. >> >> Norbert >> > > ------------------------------------------------------------------------------ > Site24x7 APM Insight: Get Deep Visibility into Application Performance > APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month > Monitor end-to-end web transactions and take corrective actions now > Troubleshoot faster and improve end-user experience. Signup Now! > http://pubads.g.doubleclick.net/gampad/clk?id=267308311&iu=/4140 > _______________________________________________ > Emc-developers mailing list > Emc-developers@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-developers > ------------------------------------------------------------------------------ Site24x7 APM Insight: Get Deep Visibility into Application Performance APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month Monitor end-to-end web transactions and take corrective actions now Troubleshoot faster and improve end-user experience. Signup Now! http://pubads.g.doubleclick.net/gampad/clk?id=267308311&iu=/4140 _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers
