On Sunday 17 July 2016 13:48:11 John Kasunich wrote: > On Sat, Jul 16, 2016, at 04:00 PM, Gene Heskett wrote: > > Greetings from your canary; > > In case of TL;DR... the important part is this sentence near the end: > > I note > > that the base-thread was set for 50,000ns, where before the > > conversion it was 30,000ns. > > If the automatic updater made that change, that is a bug. > > Everything else is irrelevant. > > The fix should be to return the base-thread to 30,000nS > . I'll do that John, as soon as the current job is done. ATM its making the slots, 2 of them, in a 1/2" piece of soft A2 with a 1/4" hole bored thru it, one slot to make a steel hinge, the other all the way thru to the bore to make compression room so it can tighten down on a 1/4" SC tool so I can bore and tap small holes. If my commercial single tooth can be coaxed into going that small. It may need further customizing.
Toy machines need toy tools, but I find more often than not, I have to make my own. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic patterns at an interface-level. Reveals which users, apps, and protocols are consuming the most bandwidth. Provides multi-vendor support for NetFlow, J-Flow, sFlow and other flows. Make informed decisions using capacity planning reports.http://sdm.link/zohodev2dev _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
