in the 'view' menu - uncheck 'show offsets' With the coordinate offsets (tlo and such) shown - the velocity disappears.
sam On 1/16/2017 9:01 AM, Gene Heskett wrote: > Greetings all; > > I am making some progress, and I'm hopeing the ferrite stuff will help. > > Progress enough that I want to complain about the dro stuff overlaid on > the backplot screen. > > Nothing I can exert in the view menu will bring up a velocity readout, > nor turn off a boatload of info that is more visual noise than helpfull > to me while I am trying to bring it to life. > > Its an extremely busy screen, covering and distracting the backplot. > > The X86 version can be configured to show what I want, but not on the pi > version. > > Can this be addressed in due time? > > I did get it to cut a lathe pawn (in air, spindle vfd wasn't powered up) > last evening, I had a dial sitting on the saddle watching X motion, and > put it in the range where it was at zero on the outer end when it had > run to completion and parked itself. Then I ran it again, and at the end > of the 2nd run, it was parked 0.041" inward from where it was parked the > first time. This difference does not show in the dro display. > > Both motor cable shields are grounded as they go by the common ground > bolt, and a separate ground strap, a 5/16" wide flat braid is attached > about 1" away from the drivers - terminal, and to this bolt. About 7" > longer than the similar braid lash-up of the Z drive. And I can hear > more "roughness" in the x drive than in the Z drive. So its getting > more noise from x than z. > > Cheers, Gene Heskett ------------------------------------------------------------------------------ Developer Access Program for Intel Xeon Phi Processors Access to Intel Xeon Phi processor-based developer platforms. With one year of Intel Parallel Studio XE. Training and support from Colfax. Order your platform today. http://sdm.link/xeonphi _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
