Sorry to be a pain but… I have tried:
linuxcnc-build: force build --branch-2.9 2000.docs And got the following: Something bad happened (see logs) I have tried master and Master instead of 2.9 and get the same result. Also when I look at this page http://buildbot.linuxcnc.org/dists/stretch/ <http://buildbot.linuxcnc.org/dists/stretch/> it shows master and 2.7 haven’t been updated since 09-Jun Cheers, Phill. > On 29 Jun 2019, at 10:21 pm, John Thornton <[email protected]> wrote: > > If the buildbot is not down it usually shows up in a few hours. If the > buildbot does not rebuild you can force it to build the docs with the > following in the #linuxcnc-devel IRC channel. > > linuxcnc-build: force build --branch-2.8 2000.docs > > You can go to the buildbot waterfall page and see the status of any queued > builds > > http://buildbot.linuxcnc.org/buildbot/waterfall > > JT > > On 6/29/2019 5:42 AM, Phillip Carter wrote: >> Is there a specific time from when a commit is pushed until it appears in >> the online docs and the buildbot?Cheers, Phill >> _______________________________________________ >> Emc-developers mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-developers > > > _______________________________________________ > Emc-developers mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-developers _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
