On Saturday 17 April 2021 12:11:32 Jon Elson wrote: > > On 04/16/2021 12:30 PM, Gene Heskett wrote: > >> Greetings all; > >> > >> I am still looking for a little help in rigid tapping. > > OK, some other thoughts. You should use Halscope to get a > trace of following error when doing the rigid tapping move, > and see if there are any spikes in the error right around > the reversal. > > One other thing, historically, the trajectory planner ran at > 1/10th the rate of the servo thread. > This is set in the .ini file. You should make sure the > traj. planner is running at the full servo thread rate.
'Twas running at 500 hz, cranked it up to 1khz. Servo rate. Thanks Jon. I'll look at the halscope when I next do some tapping as I've got a dozen holes to do for this wannabe drive. Without putting any feet on it to clamp it down. Alu prices have quadrupled in the last 18 months. And I had to order two pieces to finish the output shaft and the other half of the body. Hiway robbery w/o the gun. Just as bad, my stock of metric screws is getting scarce. It never ends, until the fat lady sings. Thanks Jon. > > > _______________________________________________ > Emc-developers mailing list > Emc-developers@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-developers Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers
