Hi Rainer >Do you use an IDE ?
No, I've tried to use eclipse before but without much luck... To be honest, I never thought I would be this deep...My custom gui is in python and there was a bunch of examples for that so I was able to struggle through it without eclipse. Kind regards, Dan On Sun, Sep 19, 2021 at 1:29 PM Daniel Dempsey <sqmathl...@gmail.com> wrote: > Hi Rainer, > > Thanks! I've been circling around the drain for a few hours now. > > My personal email is sqmathl...@gmail.com > > Thanks again, > Dan > > On Sun, Sep 19, 2021 at 12:36 PM Rainer Stelzer <r.stel...@sgs-robotics.de> > wrote: > >> Hi Daniel, >> >> I will zip and mail you the complete source tree of src/emc/task/* . >> Do you use an IDE ? >> This makes navigating the source and understanding relations and >> dependencies much easier. >> I use Eclipse/CDT (don't do this on a slow machine, it's a pain ) >> and a diff tool is very helpful,too, to show differences between files. >> >> I would suggest NOT to change the variable names. >> Esp. not something with Ethercat, CANopen, Mechatronik Link or any other >> fieldbus. >> >> IMHO Autohoming function is in no way special to any fieldbus technology. >> >> >> > I am using Delta's ASDA-A2E and I believe that they one of the brands >> used >> > in the original development . >> >> I decided to order a set of three ESTUN ProNet and one EtherCAT board >> for a ServoStar 600 >> for the Brother TC221. >> So i have them in the shelve if the day comes when the analog servo >> drives die. >> >> Until then, I will use them to set up an environment for EtherCAT >> development. >> >> >> > out before putting my lathe through commissioning. >> Good luck and keep the emergency stop close. :-) >> Lathes are nerve wrecking. Everthing so close, so much accelerated masses. >> >> next machine in retrofit line is a AXA VSC 0 (7metric tons vertical >> milling center). >> It has a unbalanced Z Axis. >> Loosing the brake if servo positioning loop is not under control will >> send the Z-Axis literally into the table. >> >> Will get funny, too. >> >> cheers >> >> Rainer >> >> >> >> >> _______________________________________________ >> Emc-developers mailing list >> Emc-developers@lists.sourceforge.net >> https://lists.sourceforge.net/lists/listinfo/emc-developers >> > _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers