Looking into file generated by post processor I used it does not print a list of tools used.
It is easy to miss one and then program in best case quit then row to insert tool is reached, not a big problem but still annoying. In best case it would also check if tool is in tool table, this check should work if each tool get a unique number. Nicklas Karlsson fre 2023-01-13 klockan 16:39 -0500 skrev Small Shop Concepts: > That can be accomplished in the post processor of most cam softwares, > it > writes the tool lost at the top of the gcode file. > > On Fri, Jan 13, 2023, 4:32 PM Nicklas SB Karlsson <n...@nksb.eu> wrote: > > > Anyone else think it would be useful with possibility to show which > > tools a loaded NC file use? > > > > Then pressing a button list with tools needed is shown. So far I > > have > > manually read the g-code file to determine which tools must be > > prepared. > > > > > > Nicklas Karlsson > > > > > > > > _______________________________________________ > > Emc-developers mailing list > > Emc-developers@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-developers > > > > _______________________________________________ > Emc-developers mailing list > Emc-developers@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-developers _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers
