Hi to you all, Referring to EN61000-4-4 Figure 7 General set-up for laboratory type test. Two reference planes are shown. One along the bottom edge of the figure which I believe implies a plane beneath ALL equipment shown - e.g. the floor of a screened room - and a second plane specifically beneath the capacitive clamp.
If testing is performed in a screened room, is the second reference ground plane required? If it is required should it be bonded to the overall reference plane ( it is insulated from the overall reference plane by floor tiles)? If not required should the clamp be bonded to the overall reference plane? Your views and comments would be most appreciated. Thank you Vic Gibling Compliance Engineer Marconi Applied Technologies ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: majord...@ieee.org with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: emc-p...@hypercom.com Dave Heald: davehe...@attbi.com For policy questions, send mail to: Richard Nute: ri...@ieee.org Jim Bacher: j.bac...@ieee.org All emc-pstc postings are archived and searchable on the web at: http://ieeepstc.mindcruiser.com/ Click on "browse" and then "emc-pstc mailing list"