Can you give a bit more input about the version you are running, how you
configured it (run in place, vs. installed), etc?
Best thing would be to look for another similar file (with the latest CVS I
would look for pumakins references, and try to replicate that).
Regards,
Alex Joni
----- Original Message -----
From: Aitor Plaza
To: Enhanced Machine Controller (EMC)
Sent: Monday, September 10, 2007 12:50 PM
Subject: [Emc-users] Compiling a new kinematic
Hello list,
We have been working on the definition of a new kinematics file for our
machine. We want to compile the file by just doing "./configure" and "make"
does not do so. Therefore, I conclude that we should change something in the
"makefile" file. Is it correct ? Which one could be the exact point where these
changes have to be made ?
Thank you very much in advance.
Aitor
------------------------------------------------------------------------------
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
------------------------------------------------------------------------------
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.5.485 / Virus Database: 269.13.12/997 - Release Date: 9/9/2007
10:17 AM
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
