Andy Ibbotson wrote:
>
> Another evening, another question,
>
> I’ve just been using the Touch Off button with V2.1.7 and come up with 
> a problem:
>
> Launch EMC
>
> Jog axes around etc.
>
> Click Touch Off for say X axis and attempt to enter 0.125” when I type 
> the first 0 (zero) an error appears in the popup window saying “bad 
> number format” once this has occurred I can’t add offsets to any axis.
>
> Close and relaunch EMC – all works as expected.
>
> Close and relaunch EMC – same problem.
>
> Is there a correct procedure for using Touch Off?
>
> Regards
>
> Andy
>
> ------------------------------------------------------------------------
>
> -------------------------------------------------------------------------
> This SF.net email is sponsored by: Microsoft
> Defy all challenges. Microsoft(R) Visual Studio 2005.
> http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
> ------------------------------------------------------------------------
>
> _______________________________________________
> Emc-users mailing list
> Emc-users@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/emc-users
>   
I've had the same issue, and (accidentally) discovered yesterday that if 
if I place the cursor in the box and backspace out one or both zero's, a 
non zero value will be accepted.

Regards
Heinz Reimer

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to