On Mon, 2007-11-05 at 08:31 -0800, Peter C. Wallace wrote: > On Mon, 5 Nov 2007, Kirk Wallace wrote: > > > Date: Mon, 05 Nov 2007 08:11:07 -0800 > > From: Kirk Wallace <[EMAIL PROTECTED]> > > Reply-To: "Enhanced Machine Controller (EMC)" > > <emc-users@lists.sourceforge.net> > > To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net> > > Subject: Re: [Emc-users] Step/Direction Drivers > > > > On Mon, 2007-11-05 at 06:11 -0800, Peter C. Wallace wrote: > >> On Sun, 4 Nov 2007, Kirk Wallace wrote: > >> > >>> Has there been any movement on adding SPI to EMC? Paul_C updated a ... snip > > non-real-time and very expensive. Could the 5i20 be configured to > > provide high speed SPI ports? > > > Yes, already does (Hostmot2) (up to 32 bit SPI) Hostmot2 also supports > step+direction, high speed UART (10 mbps), SSI (absolute encoder protocol), > quadrature counters, 10,11 or 12 bit PWM (100 Mhz base), all overlaid on > GPIO.
Where can I get more information on Hostmot2? -- Kirk Wallace (California, USA http://www.wallacecompany.com/machine_shop/ Hardinge HNC lathe Bridgeport mill conversion pending Zubal lathe conversion pending) ------------------------------------------------------------------------- This SF.net email is sponsored by: Splunk Inc. Still grepping through log files to find problems? Stop. Now Search log events and configuration files using AJAX and a browser. Download your FREE copy of Splunk now >> http://get.splunk.com/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
