You can make an output pin HIGH all the time by using "setp" in your hal
file:
setp parport.0.pin-MM-out 1
^^ replace MM with the pin number
However, parport pin 13 is an input to the PC, not an output (see
http://linuxcnc.org/docs/2.2/html/hal_drivers.html#fig:Parport-block-diag) EMC
cannot set this pin to HIGH or LOW.
Jeff
-------------------------------------------------------------------------
SF.Net email is sponsored by:
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://sourceforge.net/services/buy/index.php
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
