On Dec 9, 2007, at 10:14 AM, Chris Radek wrote: > This stutter could cause position loss or even a complete stall on > some machines. My motors run faster and require acceleration to get > up to speed, so a stutter like that will stall them for the > entire remainder of the move! > > I'm glad that EMC warned you of the trouble, and also glad that you > were able to fix it.
I wasn't implying that it's not an issue, because it certainly is. It wasn't a big issue with my initial testing and my setup. It needed to be fixed and I am also glad that I was warned about it. >> >> So yes, I've tested it on a real machine, and the air I cut looks >> very >> nice... :) > > This is good to know! I doubt stepconf is completely bug-free, as > it's so new, but I think it works for the basic setup and if people > give it the right numbers they'll get it going. I had no issues with stepconf. There is an interface bug where you have to click off the next button on the axis setup then click next to advance to the next axis. You can't just next-next-next through it. Sheldon ------------------------------------------------------------------------- SF.Net email is sponsored by: Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
