If you you just need one channel of ADC, my DAC setup: http://www.wallacecompany.com/machine_shop/EMC2/serial_dac/
could be modified to run an ADC like the LTC1286: http://www.linear.com/pc/downloadDocument.do?navId=H0,C1,C1155,C1001,C1158,P1445,D2760 It would take up two parallel port outputs and one input and update at servo-thread speeds. On Tue, 2007-12-25 at 07:37 -0600, John Thornton wrote: > Anyone use the modbus serial card with EMC2? It has 4 bit analog input that > could > tell me my arc voltage... Also the control pendant they sell could be used > with the > modbus card... Any drawbacks to using this? > > Thanks > John -- Kirk Wallace (California, USA http://www.wallacecompany.com/machine_shop/ Hardinge HNC lathe, Bridgeport mill conversion, doing XY now, Zubal lathe conversion pending) ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
