>> Was wondering if you had any issues using M66. No issues with M66. I am using it only once. There is a switch on the conveyor that triggers when a board hits the board stop. Once this is triggered, two actuators lift the board from the conveyor and pin it up on a set of guide rails, then another actuator pushes pins in to lock the board up against the front rail, which is assumed to be inline with my x-axis.
>> was it something else besides the number of motion controlled IO that made you recompile? It was the number of IO. Why does there need to be a limit on this? Can the motion controller not read and assign the number as needed? >> Where do you live? In Central Illinois, about 30 minutes south of Galesburg, actually. I mention Galesburg because that is where the CNC Workshop is held. So if anyone wants to swing by and watch it run while they are in town for the Workshop, let me know. Concerning the other machines, I won't be doing anything with them until it warms up. And one may have a hard time finding feeders for them. I believe that MannCorp is what used to be Mamiya, but I cannot confirm that. I have seen some MannCorp feeders that look from a distance like these, but I cannot confirm that yet either. >Len ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
