That would depend on the accuracy of your scales... .00004" precision (.001mm)is not cheap...
In my case mine are not nearly that accurate... I guess it depends on how much accuracy is needed and the future of the machine. EMC does have screw mapping... John On 1 Feb 2008 at 4:04, [EMAIL PROTECTED] wrote: > The DRO is, quite differently, measuring the *actual* X Y Z position, > if the DRO says you are 100.000 mm from point A then you can take it > to the bank. ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users