I have installed the same board with no problems, Running on the following.....
Pentium4, 2ghz Dell Diminsion 8200 with 768megs of ram. First I installed the
card with default jumper settings and then loaded EMC 2.2.2. All I/Os work
fine. It should be set for board ID "0".....EMC will not run at all with the
board removed using the Motenc config files. You should get error
messages.....Did you also buy the 8/16 I/O boards and the analog card?
Dave Keeton
----- Original Message -----
From: Dave Engvall
To: Enhanced Machine Controller (EMC)
Sent: Thursday, February 21, 2008 7:07 PM
Subject: Re: [Emc-users] not recognized motenc-lite card
Hi,
You might try checking the board ID jumpers; it looks like both need to be in
place for board 0.
I don't have a -Lite board but do have the 8 channel board.
Try starting emc with the board not installed and see if you get a message
something like "board not found" or "board not installed". Usually almost the
last thing in the error window.
Then check the jumpers, install the board and go again.
The "Lite" board was used in the Mazak conversion at Fest and worked quite
well. Check the wiki for more information on the conversion.
Good luck.
Dave
On Feb 21, 2008, at 12:52 PM, cnc eafit wrote:
Hi there
I just bought a Motenc-lite card that is suposoused to be supported by
linuxcnc. But when I booted the system it does not come up. I'm totally lost
I've been unable to find documentation to fix the problem.
thanks in advance
CARD:
MOTENC-Lite 4 axes PCI MOTION & I/O control board
linuxcnc installed form the lastest cd and updated to 2.2.3
lspci
0000:02:07.0 Bridge: PLX Technology, Inc.: Unknown device 3001 (rev 01)
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
------------------------------------------------------------------------------
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
------------------------------------------------------------------------------
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
