On Thursday 27 March 2008, John Thornton wrote: >Here is the link for the chipload drilling article. Took me a while to find > it... > >http://www.practicalmachinist.com/vb/showthread.php?p=862651#post862651 > >Enjoy >John
Thanks, John. I could have used that today, I broke a 0.050" bit in cast iron, about 1/4" down on the second peck by mouse control, & another .3" to go. I wound up moving the hole, but not quite far enough & dinged up a 1/4-28 tap on the remains. Using a properly programmed peck cycle, I imagine I can do the next one just fine by following that advice. I was installing a grease fitting, and that was the channel into the bearing bore. I got all the parts to put ball bearing thrust washers in the screw bearings of my micromill today, so I ran out and put in the first pair. Sweet! No more squalling screws & the backlash is now .0004"! I can't wait to get the other axis done, but this cold rain ran me out of the shop till it warms a bit again. -- Cheers, Gene "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) ... I see TOILET SEATS ... ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users