Chris - what is a typical number of pulses per second that EMC2 can generate on one of these with 256Mb of RAM? I'd like to compare it to what I am currently using.
Andy Chris Radek wrote: > On Thu, Oct 30, 2008 at 02:10:59PM +0000, alan wrote: >> I have built an ornamental turning lathe with stepper control, on a >> moveable stand and I am really looking for something that sits on a >> narrow shelf under the lathe next to my stepper controller box. So I am >> looking for a eorocard or smaller sized pc with sufficient memory size >> (whatever that is ). Anyone got a best buy suggestion? > > > http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=300268637293 > > I have used these successfully. They have fine realtime performance. > They have parallel and serial ports. They take a full size IDE hard > disk. There are lots of them around and they are cheap. > > If you buy one beware it will only handle 256MB of RAM and also be > sure you get the power pack with it. The RAM is the only real > limitation. I have not tried the later (P4) models. -- Andy PGP Key ID: 0xDC1B5864 ------------------------------------------------------------------------- This SF.Net email is sponsored by the Moblin Your Move Developer's challenge Build the coolest Linux based applications with Moblin SDK & win great prizes Grand prize is a trip for two to an Open Source event anywhere in the world http://moblin-contest.org/redirect.php?banner_id=100&url=/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users