I just set up EMC using the Stepconf wizard. I ran a few test programs with mixed results. I am seeing a Joint 1 Following error quite a bit. I am going to do some troubleshooting tonight, including installing a graphics card and disabling the on board graphics chips. My latency test result was around 37,000 (if I remember correctly) after a few minutes of running it.
This is a stepper setup and I am using the same velocity and acceleration that I used for a demo install of Mach 3 on the same computer. In Mach3, the machine worked great, I just thought I'd give EMC a try instead of spending money on Mach3. Any ideas of what I should try first regarding a Joint 1 following error? What exactly is this error? Thanks for any input you guys are able to give. Cheers, Dan ------------------------------------------------------------------------- This SF.Net email is sponsored by the Moblin Your Move Developer's challenge Build the coolest Linux based applications with Moblin SDK & win great prizes Grand prize is a trip for two to an Open Source event anywhere in the world http://moblin-contest.org/redirect.php?banner_id=100&url=/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
