Following error is usually a result of the acceleration or velocity set too high.
More info here... http://www.linuxcnc.org/docview/html//common_Stepper_Diagnostics.html John On 3 Nov 2008 at 10:02, Dan Clarke wrote: > I just set up EMC using the Stepconf wizard. I ran a few test > programs with mixed results. I am seeing a Joint 1 Following error > quite a bit. I am going to do some troubleshooting tonight, including > installing a graphics card and disabling the on board graphics chips. > My latency test result was around 37,000 (if I remember correctly) > after a few minutes of running it. > > This is a stepper setup and I am using the same velocity and > acceleration that I used for a demo install of Mach 3 on the same > computer. In Mach3, the machine worked great, I just thought I'd give > EMC a try instead of spending money on Mach3. > > Any ideas of what I should try first regarding a Joint 1 following > error? What exactly is this error? > > Thanks for any input you guys are able to give. > > Cheers, > > Dan > ---------------------------------------------------------------------- > --- This SF.Net email is sponsored by the Moblin Your Move Developer's > challenge Build the coolest Linux based applications with Moblin SDK & > win great prizes Grand prize is a trip for two to an Open Source event > anywhere in the world > http://moblin-contest.org/redirect.php?banner_id=100&url=/ > _______________________________________________ Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------- This SF.Net email is sponsored by the Moblin Your Move Developer's challenge Build the coolest Linux based applications with Moblin SDK & win great prizes Grand prize is a trip for two to an Open Source event anywhere in the world http://moblin-contest.org/redirect.php?banner_id=100&url=/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
