i'm not an expert, but i dont think any position critical motion control being done over wireless would be a good idea, especially if it was a cheap wireless solution. I would think that it would be susceptible to noise ad interference, which could cause parts of the machine being somewhere they aren't supposed to be.
Is there any reason you cant just run 4 wires there? or 8 if you want to convert the parallel port to differential logic(3 signals, their suppliment signals, ground and +supply for the differential to open ended logic converter circuit. I would trust copper more than RF. If i did go RF i would avoid anything higher than 900 mhz due to penetration / signal reflection issues. also plenty of power to make sure nothing around overpowers your transmitted signal. good luck in your build Jim On Wed, Nov 26, 2008 at 3:37 PM, Olusegun A. <[EMAIL PROTECTED]> wrote: > Good day all, > Please I would be glad if someone could help me out with a simple RF DATA > LINK TRANSMITTER AND RECEIVER for Parallel port. I intend to extend my > paralle port by wireless means. I got one but I could not get the ICs here > in Nigeria, Even if the circuit will just transmit only 3 pins of the > Paralel port and ground. Thank you all > > Olusegun Abode > +234 8037045535 > Email:[EMAIL PROTECTED] <[EMAIL PROTECTED]> > ------------------------------------------------------------------------- This SF.Net email is sponsored by the Moblin Your Move Developer's challenge Build the coolest Linux based applications with Moblin SDK & win great prizes Grand prize is a trip for two to an Open Source event anywhere in the world http://moblin-contest.org/redirect.php?banner_id=100&url=/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
