Take a look at the Arc Buddy on the wiki site on the g code generators page it will show you the proper code for an arc.
John On 15 Jan 2009 at 18:40, Yuri wrote: > hi guys, > > I have this error at line 10 (g2 code) when I try to load following > code > into emc2. > I tried to set up MM_TOLERANCE=0.01 (even tried 0.1 and 1 values) > with same > error. > I took a look at my emc tool table and it has Zero diameter tool. > Previously I tried to generate this code with 3 decimal digits with > same > error. > > % > G90 > T1 > G0X0Y0Z0M8 > Z15. > X-6.31398Y.25112 > Z10. > G1Z1.00118F250. > X-6.30148F400. > G2X-6.15148Y.18898I0J.21213 > G3X-6.00148Y.25112I-.06213J-.06213 > G1Y.50104 > X-5.97067Y.46952 > X-5.96747Y.4663 > > ..... > > What should I do ? > > Thanks, > obana > -------------------------------------------------------------------- > ---------- > This SF.net email is sponsored by: > SourcForge Community > SourceForge wants to tell your story. > http://p.sf.net/sfu/sf-spreadtheword > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ This SF.net email is sponsored by: SourcForge Community SourceForge wants to tell your story. http://p.sf.net/sfu/sf-spreadtheword _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users