On Wed, 22 Jul 2009, Pablo Pais wrote: > Date: Wed, 22 Jul 2009 10:56:50 -0300 > From: Pablo Pais <[email protected]> > Reply-To: "Enhanced Machine Controller (EMC)" > <[email protected]> > To: [email protected] > Subject: [Emc-users] PC/104 Install > > Hello, > Someone knows about install linuxcnc on a PC/104 sistem. > Thanks > Pablo
I think the trick there is to find a PC/104 CPU with decent latency and a parallel port (if you are using parallel I/O to control the machine) PC/104 CPUs are not cheap so selecting a CPU card by trial end error is liable to be an expensive project... > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > Peter Wallace Mesa Electronics (\__/) (='.'=) This is Bunny. Copy and paste bunny into your (")_(") signature to help him gain world domination. ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
