Hi, I have several Advantech PCM-9375 PC104 boards (project leftovers). These run plain Ubuntu 8.04 (LAMP) very well but freezes near the end of an attempted install of EMC2 from an USB stick. I could not find any diagnostic feedback, mostly because I don't know where to look in a noncomplete install. This was a while ago, and I have sort of given up for now, but it would be a nice package if it worked. I did not get as far as being able to check on latency.
FWIW, Lars > -----Original Message----- > From: Peter C. Wallace [mailto:[email protected]] > Sent: den 22 juli 2009 17:58 > To: Enhanced Machine Controller (EMC) > Subject: Re: [Emc-users] PC/104 Install > > On Wed, 22 Jul 2009, Pablo Pais wrote: > > > Date: Wed, 22 Jul 2009 10:56:50 -0300 > > From: Pablo Pais <[email protected]> > > Reply-To: "Enhanced Machine Controller (EMC)" > > <[email protected]> > > To: [email protected] > > Subject: [Emc-users] PC/104 Install > > > > Hello, > > Someone knows about install linuxcnc on a PC/104 sistem. > > Thanks > > Pablo > > I think the trick there is to find a PC/104 CPU with decent latency > and a parallel port (if you are using parallel I/O to control the > machine) > > PC/104 CPUs are not cheap so selecting a CPU card by trial end error is > liable to be an expensive project... > > > > > ----------------------------------------------------------------------- > ------- > > _______________________________________________ > > Emc-users mailing list > > [email protected] > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > Peter Wallace > Mesa Electronics > > (\__/) > (='.'=) This is Bunny. Copy and paste bunny into your > (")_(") signature to help him gain world domination. > > > ----------------------------------------------------------------------- > ------- > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
