On Fri, May 21, 2010 at 2:50 PM, Michael Jones
<[email protected]> wrote:
> I'm currently having problems with a reinstall after switching some
> stuff around.
>
> I recently moved some hardware around in my shop. I decided I didn't
> need that nice LCD monitor on the CNC machine so I switched out a
> decent CRT monitor (Higher resolution etc). For some reason the
> system would no longer support any resolution higher than 800x600
> (even though it had run as 1024x768 on the LCD).
I am guessing that the CRT is of the older type and it doesn't report
its available resolutions, unlike the LCD.
I would reinstall the EMC version that worked best on your hardware,
and then edit the X configuration file
to explicitly specify the monitor parameters (horizontal and vertical
frequency range), along the lines of
Section "Monitor"
Identifier "CM752ET"
HorizSync 31-101
VertRefresh 60-160
EndSection
and call out the desired display resolution in Section "Screen"
Section "Screen"
Identifier "Default Screen"
Monitor "CM752ET"
DefaultDepth 16
SubSection "Display"
Depth 16
Modes "1280x1024"
EndSubSection
EndSection
------------------------------------------------------------------------------
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
