Hi Guys. I have a Saitek P800 joypad configured as a mill control. It is awesome.
It has one parameter pre-set: setp halui.jog-speed 30 # desired maximum jog speed mm/min Then I have a few buttons configured for jogging: net velX input.0.abs-rz-position => joyhandle.0.in net velXout joyhandle.0.out => halui.jog.0.analog net velY input.0.abs-z-position => joyhandle.1.in net velYout joyhandle.1.out => halui.jog.1.analog net velZ input.0.abs-y-position => joyhandle.2.in net velZout joyhandle.2.out => halui.jog.2.analog And I have some buttons configured for misc stuff: # Flood on and off buttons 1 and 2 net floodOff input.0.btn-thumb2 => halui.flood.on net floodOn input.0.btn-trigger => halui.flood.off and so on. What I want to do is to change the default jog speed from the joypad. Somehow I want two buttons, one for decreasing halui.jog-speed and one for increasing. Say I have them called example1 and example2 buttons. Could I say something like net increaseJog input.0.btn-example1 => halui.jog-speed.increase net increaseJog input.0.btn-example2 => halui.jog-speed.decrease Clearly my syntax is wrong, but is there some way of changing max jog speed from the joypad itself? Thanks a lot. I am loving every minute of using EMC2. i ------------------------------------------------------------------------------ This SF.net Dev2Dev email is sponsored by: Show off your parallel programming skills. Enter the Intel(R) Threading Challenge 2010. http://p.sf.net/sfu/intel-thread-sfd _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
