On Wed, Sep 1, 2010 at 4:48 PM, Andy Pugh <[email protected]> wrote: > On 1 September 2010 19:59, rng3 <[email protected]> wrote: > >> here..http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?Simple_Remote_Pendant >> John has set this up with 3 proportional jog speeds . > > I have a slightly different bit similar arrangement. It has the mux4 > but not the or2. Speed is zero with neither of the rear-left buttons > pressed, fast with the top pressed, medium with the bottom pressed, > and very slow with both pressed.
And, would it be possible to see a relevant fragment of your HAL file? Thanks i ------------------------------------------------------------------------------ This SF.net Dev2Dev email is sponsored by: Show off your parallel programming skills. Enter the Intel(R) Threading Challenge 2010. http://p.sf.net/sfu/intel-thread-sfd _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
