On Fri, Sep 3, 2010 at 1:18 PM, Jon Elson <el...@pico-systems.com> wrote:

> OK, you have the newest boards with the switching power supply, the current
> consumption is much less that the earlier models, around 150 mA by
> itself, about 200 mA with the
> spindle DAC accessory board.  The board will run from ~7 to 25 V (the input
> capacitor is the limiting factor).  Current draw will go inversely with
> voltage,
> as the switcher makes for a constant power input.
>
> I usually use the 412-109034 wall wart from Mouser, the listed rating is
> 9 V 300 mA,
> but in fact it puts out about 11.8 V at light load.
>
> Jon
>
> Thanks Jon; that was my need.
    Don

------------------------------------------------------------------------------
> This SF.net Dev2Dev email is sponsored by:
>
> Show off your parallel programming skills.
> Enter the Intel(R) Threading Challenge 2010.
> http://p.sf.net/sfu/intel-thread-sfd
> _______________________________________________
> Emc-users mailing list
> Emc-users@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/emc-users
>
------------------------------------------------------------------------------
This SF.net Dev2Dev email is sponsored by:

Show off your parallel programming skills.
Enter the Intel(R) Threading Challenge 2010.
http://p.sf.net/sfu/intel-thread-sfd
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to