For what it's worth. I stumbled across this by accident..... At a tool
change take your tool to an area where there's still a surface z0.000. End the
move with z1.000. Remove the tool, and insert the new tool. Now use a clamp arm
from your clamp kit that is 1" on a side. Raise or lower the knee until your
tool is just touching the upper surface of your clamp arm. You're now indexed
1.00x inches above your work.
Andrew
------------------------------------------------------------------------------
This SF.net Dev2Dev email is sponsored by:
Show off your parallel programming skills.
Enter the Intel(R) Threading Challenge 2010.
http://p.sf.net/sfu/intel-thread-sfd
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
