On 9 September 2010 15:52, John Kasunich <[email protected]> wrote:
> A dowel pin works great for this - very precise, and you can simply > push it against the side of the tool, then raise the tool (or lower > the knee) slowly until the pin rolls under. I think I have just found a use for the shank of the 6mm carbide milling cutter I broke. -- atp ------------------------------------------------------------------------------ This SF.net Dev2Dev email is sponsored by: Show off your parallel programming skills. Enter the Intel(R) Threading Challenge 2010. http://p.sf.net/sfu/intel-thread-sfd _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
