> So what I'm asking is, is it possible to edit the configuration in such a
> way that I can configure output pins to send a signal to enable the X/Y/Z
> axis?
>
> Cheers,
> KEv.
This is what the 'amplifier enable' signal (in stepconf) is for.
You can actually add it to more then one parport pin if you
need more then one.
Chris M
------------------------------------------------------------------------------
Forrester Wave Report - Recovery time is now measured in hours and minutes
not days. Key insights are discussed in the 2010 Forrester Wave Report as
part of an in-depth evaluation of disaster recovery service providers.
Forrester found the best-in-class provider in terms of services and vision.
Read this report now! http://p.sf.net/sfu/ibm-webcastpromo
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
