This subjects has been covered before but I need some advice. I have two FANUC S420-iF's with RJ2 controllers that I would like to use with G-code to do routing, adhesive placement, trimming etc. Where do I start? What components should be used etc? I understand the electronics least and was told I could use generic Allen Bradley Servo controllers along with software like EMC2, is this correct??
Thanks, JOSH ------------------------------------------------------------------------------ Fulfilling the Lean Software Promise Lean software platforms are now widely adopted and the benefits have been demonstrated beyond question. Learn why your peers are replacing JEE containers with lightweight application servers - and what you can gain from the move. http://p.sf.net/sfu/vmware-sfemails _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
