Maybe im using the wrong command because i tried it in the postgui I am using setp spindle-vfd.nameplate-RPM 1760
Sent from my iPod On Sep 7, 2011, at 2:15 PM, andy pugh <bodge...@gmail.com> wrote: > On 7 September 2011 21:03, Brian May <bri...@do-precision.com> wrote: > >> I am using the GS2 driver to communicate to a automation direct GS3 motor >> controller. It seems to be working fine. However, I need to set the >> parameter spindle-vfd.nameplate-RPM in a hal configuration file and I keep >> getting errors that says the parameter does not exist. Once I load EMC I >> can go into the hal configuration and set it there - but for some reason I >> cannot set in the HAL file. Any ideas what I am doing wrong? > > It is likely that the component that creates the pin in question is > loaded after the place where you are trying to connect it, either in a > HAL file that loads later in the sequence, or in a GUI element. > > If you put the net command in the postgui.hal file in your config it > will work for either situation. > > -- > atp > "Torque wrenches are for the obedience of fools and the guidance of wise men" > > ------------------------------------------------------------------------------ > Using storage to extend the benefits of virtualization and iSCSI > Virtualization increases hardware utilization and delivers a new level of > agility. Learn what those decisions are and how to modernize your storage > and backup environments for virtualization. > http://www.accelacomm.com/jaw/sfnl/114/51434361/ > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Using storage to extend the benefits of virtualization and iSCSI Virtualization increases hardware utilization and delivers a new level of agility. Learn what those decisions are and how to modernize your storage and backup environments for virtualization. http://www.accelacomm.com/jaw/sfnl/114/51434361/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users