On 10/27/2011 06:20 PM, Tom Easterday wrote:
> Is there a command or parameter that can be set while EMC/Axis is running 
> that will make it ignore following error (and then after issuing again - pay 
> attention to ferror)?  I want to have my servo drive control an axis and I 
> want EMC to ignore it while I do this, then take back over control.  But I 
> don't want to have to disable Axis.

Use halcmd to temporarily set your axis.N.f-error-lim pins to some silly 
high value?

-- 
Sebastian Kuzminsky


------------------------------------------------------------------------------
The demand for IT networking professionals continues to grow, and the
demand for specialized networking skills is growing even more rapidly.
Take a complimentary Learning@Cisco Self-Assessment and learn 
about Cisco certifications, training, and career opportunities. 
http://p.sf.net/sfu/cisco-dev2dev
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to