I found PNCConf and this is what I have setup so far. Not sure what half the
bits are.
Lathe_Copley
Axis XZ Lathe
Machine Units mm
Test Base Jitter
Computer response time 1029317 Max Intgerval
Base Thread 742185
Actual Serv Period - 100000
I/O
Mesa 5I20
GUI Axis
External Controls - No Change
Front end No Change
Virtual Control No Change
Defaults
Require Homing before MDI
Popup Tool Change Prompt
MESA I/O Setup 7I48
Firmware SVST8_4
PWM Base Frequency 24000
PDM Base Ferquency 6000
WatchDog Timer 10000000
Num Encoders 3
Num of pwm Generators 3
Step Get 0
Total Numebr of Pins 72
ACCEPT CHANGES
I/O Connector 2
0: X Encoder
2: Z Encoder
0: X Axis PWM - Pulse Width Gen-P
2: z Axis PWM - Pulse Width Gen-P
I/O Connector 3
024: X Limit +
025: X Limit -
026: X Home
032: Z Limit +
033: Z Limit -
034: Z Home
036: EStop
037: Start
037: Stop
038: Single Step
X and Z unchanged for the momemt
Advanced Options - None
Hal Component Page No change
When I run the diagnostcs for the Mesa card I get
PNCconf encountered an error. The following information may be useful in
troubleshooting:
Traceback (most recent call last):
File "/usr/bin/pncconf", line 5398, in on_mesapanel_clicked
self.halrun.close()
KeyboardInterrupt
Anyone have a MESA Lathe configuration I an look at ?
Cheers Wallace
------------------------------------------------------------------------------
LogMeIn Rescue: Anywhere, Anytime Remote support for IT. Free Trial
Remotely access PCs and mobile devices and provide instant support
Improve your efficiency, and focus on delivering more value-add services
Discover what IT Professionals Know. Rescue delivers
http://p.sf.net/sfu/logmein_12329d2d
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
