LinuxCNC is free. :) On Jun 24, 2013 5:34 PM, "Dave" <e...@dc9.tzo.com> wrote:
> On 6/24/2013 12:17 PM, Florian Rist wrote: > > Hi > > > > > >> Yes, the best option if someone _really_ wanted to do this seems to be > >> running the rsh interface and just sending gcodes one at a time as MDI > >> commands. > >> > > Well, I did something like that using rsh recently, but there is a big > > problem with it: As far as I can see a continuous motion (G64) is not > > possible. So the machine comes to a full stop after each command. > > > > See you > > Flo > > > > > Sounds like a case of GroupThink on the part of the 3D printer folks. > > DNC/Dripfeed implies obsolete controls. There are a couple of pretty > good DNC program available online for free. (Hence their true value.) > > Dave Cole > > > ------------------------------------------------------------------------------ > This SF.net email is sponsored by Windows: > > Build for Windows Store. > > http://p.sf.net/sfu/windows-dev2dev > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ This SF.net email is sponsored by Windows: Build for Windows Store. http://p.sf.net/sfu/windows-dev2dev _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users