If you have a vice, or even just a good sharp square edge part that you can set X/Y axis zero with an edge finder or wiggler, then move your camera cross hairs into position and note the correction factor on the DRO position screen.
As to the camera mount - how about a male/female pair of vee shaped dovetails say 10 degrees off vertical for each side. you could then just drop in the male part and it would taper lock to the same position by gravity every time, yet allow you to lift it off without fasteners so it stays clean while cutting. Also (hint hint) 30mm is a popular scope ring size, you could likely find some noname chi import ones in the sub $10 range that would work for you. ------------------------------------------------------------------------------ Introducing Performance Central, a new site from SourceForge and AppDynamics. Performance Central is your source for news, insights, analysis and resources for efficient Application Performance Management. Visit us today! http://pubads.g.doubleclick.net/gampad/clk?id=48897511&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
