> From: [email protected]
> To: [email protected]
> Date: Fri, 4 Oct 2013 13:46:29 +0100
> Subject: Re: [Emc-users] Following Error with Steppers
>
> Quoth andy pugh.....
> >On 4 October 2013 11:19, Russell Brown <[email protected]> wrote:
> >
> >> Mesa_Mill.hal:124: Pin 'motion.spindle-speed-out-rps-abs' does not exist
> >
> >The pin was added in this commit:
> >http://git.linuxcnc.org/gitweb?p=linuxcnc.git;a=commit;h=71f6326a9e2585122856a77619dfeae193a61d5d
> >
> >Which isn't in 2.5.3.
> >I think the problem is a miss-match between the pncconf version and
> >the LinuxCNC version. I am not sure if they should be tied quite so
> >closely to each other.
>
> Ah. OK as you were. Yes the generated config doesn't produce an error
> when run with 2.6.0~pre.
>
> --
> Regards,
> Russell
Yes as you discovered there are some master-only pins.
I will cherry pick the relevant changes to 2.5.3 soon.
Thanks for testing.
------------------------------------------------------------------------------
October Webinars: Code for Performance
Free Intel webinars can help you accelerate application performance.
Explore tips for MPI, OpenMP, advanced profiling, and more. Get the most from
the latest Intel processors and coprocessors. See abstracts and register >
http://pubads.g.doubleclick.net/gampad/clk?id=60134791&iu=/4140/ostg.clktrk
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
