The G-code looks like ordinary 3 axis XYZ code, with an L code command that slaves the other 3 axis (UVW)to the Z in the preamble of the file. The L code is L12ZZZZ. Then just L12 cancels the slaving (or you could use L12ZWUV) This is all kind of a mute point since the original post I was replying to wasn't even talking about WinCNC.
----- Original Message ----- From: "andy pugh" <bodge...@gmail.com> To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net> Sent: Thursday, October 10, 2013 7:27:55 AM Subject: Re: [Emc-users] Perceived issues with LinuxCNC. On 10 October 2013 12:22, Todd Zuercher <zuerc...@embarqmail.com> wrote: > Our set up is on a multi head gang router (4 independent Z axis). This is a > relatively simple configuration in WinCNC but would be very difficult to > configure in LinuxCNC. What does the G-code look like for that? -- atp If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ October Webinars: Code for Performance Free Intel webinars can help you accelerate application performance. Explore tips for MPI, OpenMP, advanced profiling, and more. Get the most from the latest Intel processors and coprocessors. See abstracts and register > http://pubads.g.doubleclick.net/gampad/clk?id=60134071&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ October Webinars: Code for Performance Free Intel webinars can help you accelerate application performance. Explore tips for MPI, OpenMP, advanced profiling, and more. Get the most from the latest Intel processors and coprocessors. See abstracts and register > http://pubads.g.doubleclick.net/gampad/clk?id=60134071&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
