On 11 November 2013 11:35, Viesturs Lācis <[email protected]> wrote:
> The problem is that I cannot figure out, how to get threading to work. G76
> command will bring the tool along X to proper thread depth and then stop.
> It seems to me that it is waiting for a signal on
> motion.spindle-index-enable.
Maybe, maybe not :-)
The common reasons for going to the start of the thread and then not
proceding is a problem with motion.spindle-revs not be hooked up.
("revs" means "revolutions", not "revolutions per minute")
If this pin is actually connected then it maybe that it is counting in
the wrong direction. it needs to count up for normal spindle rotation.
(and it needs to count up at 1 unit per revolution)
The spindle-enable reference you found it something completely different.
This is probably the reference you need:
http://linuxcnc.org/docs/html/examples/spindle.html#_spindle_synchronized_motion_a_id_sec_spindle_synchronized_motion_a
--
atp
If you can't fix it, you don't own it.
http://www.ifixit.com/Manifesto
------------------------------------------------------------------------------
November Webinars for C, C++, Fortran Developers
Accelerate application performance with scalable programming models. Explore
techniques for threading, error checking, porting, and tuning. Get the most
from the latest Intel processors and coprocessors. See abstracts and register
http://pubads.g.doubleclick.net/gampad/clk?id=60136231&iu=/4140/ostg.clktrk
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
