You need to motion.spindle-forward hooked to something... so
net spindle-forward-button motion.spindle-forward sam On 2/28/2014 9:18 AM, Mark Tucker wrote: > My spindle is currently working no problem using G code or m3 and m5 in mdi. > But the spindle button is not showing in the axis gui. > I have the following in my hal file:- > > # This output is on DB25-14 and is currently tied to spindle control (M3/M5) > net Output1 bb_gpio.p8.out-13 => halui.spindle.is-on > setp bb_gpio.p8.out-13.invert 1 > > Should i add something to get the button to show in Axis? > > > > ------------------------------------------------------------------------------ > Flow-based real-time traffic analytics software. Cisco certified tool. > Monitor traffic, SLAs, QoS, Medianet, WAAS etc. with NetFlow Analyzer > Customize your own dashboards, set traffic alerts and generate reports. > Network behavioral analysis & security monitoring. All-in-one tool. > http://pubads.g.doubleclick.net/gampad/clk?id=126839071&iu=/4140/ostg.clktrk > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > > ------------------------------------------------------------------------------ Flow-based real-time traffic analytics software. Cisco certified tool. Monitor traffic, SLAs, QoS, Medianet, WAAS etc. with NetFlow Analyzer Customize your own dashboards, set traffic alerts and generate reports. Network behavioral analysis & security monitoring. All-in-one tool. http://pubads.g.doubleclick.net/gampad/clk?id=126839071&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users