2014-05-16 16:37 GMT+03:00 Peter C. Wallace <p...@mesanet.com>: > > > Did you power cycle the CPU after flashing the card?
No, I didn't. Manual does not say that it should be done. Anyway, I tried today and it kind of seemed to be allright, it even moved both motors on one of the 7i39s. I just have no idea, what kind of shit happened, maybe just another moment of bad luck on this awful day, because one of 7i39 had a nice flame, the other one does not light any LEDs and 5i24 is not found by LinuxCNC anymore - tried restarting pc several times, put it in different pci slot, 5i24 is not recognized, although power LEDs on replaced 7i39s do turn on. There were no lose wires to make any shortcircuits, I have no idea, what could have happened to 7i39, CR8, CR9 and CR12 flickered few times and then the orange C1 catched small flame. It seems to me that logic power was shorted to motor power and then it was baked, but I have no idea, where and how could something like that happen. Fortunately I bought two 5i24s and had two spare 7i39s, so I flashed 5i24 with the firmware, turned PC off for a moment, turned it on and the board seemed to be just fine, but the problem is that pwmgens are not enabled on 7i39 that is attached to P2. I swapped 7i39 cards, I swapped cables, but the problem remains on P2 connector. HalShow shows that all 3pwmgen enable pins are turned on, so I have no idea, what is wrong. Any ideas? Viesturs ------------------------------------------------------------------------------ "Accelerate Dev Cycles with Automated Cross-Browser Testing - For FREE Instantly run your Selenium tests across 300+ browser/OS combos. Get unparalleled scalability from the best Selenium testing platform available Simple to use. Nothing to install. Get started now for free." http://p.sf.net/sfu/SauceLabs _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
