Thanks Jeff. On 2014-09-01 18:23, Jeff Epler wrote: > From the "motion" manpage: > > motion.spindle-at-speed IN BIT > Motion will pause until this pin is TRUE, under the > following > conditions: before the first feed move after each spindle > start > or speed change; before the start of every chain of > spindle-syn‐ > chronized moves; and if in CSS mode, at every rapid->feed > tran‐ > sition. > http://linuxcnc.org/docs/2.6/html/man/man9/motion.9.html > > In the situation you describe, the docs indicate that motion will continue, > not be paused. > > Jeff > > ------------------------------------------------------------------------------ > Slashdot TV. > Video for Nerds. Stuff that matters. > http://tv.slashdot.org/ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users
-- Regards /Groete Marius D. Liebenberg +27 82 698 3251 +27 12 743 6064 QQ 1767394877 ------------------------------------------------------------------------------ Slashdot TV. Video for Nerds. Stuff that matters. http://tv.slashdot.org/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
