On 4 November 2014 11:52, Dr. Nikolaus Klepp <dr.kl...@gmx.at> wrote:
> Is it normal that a G1 followed by a G2/G3 slows the feed speed to an almost > halt at the transition point, but executing G2/G3 follwed by G1 works without > speed loss? It is normal if the machine has very low acceleration values and high speed. It is much more noticeable on some machines than on others. There is a new trajectory planner in the works to address this problem. You can obtain the experimental 2.7 pre-release if you want to try it. http://wiki.linuxcnc.org/cgi-bin/wiki.pl?UpdatingTo2.7 -- atp If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
