Am Dienstag, 4. November 2014 schrieb Viesturs Lācis: > 2014-11-04 13:52 GMT+02:00 Dr. Nikolaus Klepp <dr.kl...@gmx.at>: > > Hi all! > > > > Is it normal that a G1 followed by a G2/G3 slows the feed speed to an > > almost halt at the transition point, but executing G2/G3 follwed by G1 > > works without speed loss? Is there a way to work around this problem? The > > same problem occures on G2/G3 G2/G3 transition. > > > > It depends on G61/G61.1/G64 (P xx) commands - check out their meaning here: > http://linuxcnc.org/docs/html/gcode/gcode.html#sec:G61-G61_1 > > You might want to try G64 with small blending tolerance, like 0,05 mm. > That would look like G64 P0.05 in the beginning of your g-code file. > > It also depends, if any of those G1 are tangents to G2/G3 (also of > both G2/G3 are tangents). > > Viesturs
Thank you, that solved the problem :-) My header included "G64 P0.01" which was a bit too tight. Nik ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
