On Tuesday 30 June 2015 21:48:22 Peter C. Wallace wrote: > On Tue, 30 Jun 2015, Gene Heskett wrote: > > Date: Tue, 30 Jun 2015 21:32:48 -0400 > > From: Gene Heskett <[email protected]> > > Reply-To: "Enhanced Machine Controller (EMC)" > > <[email protected]> > > To: "Enhanced Machine Controller (EMC)" > > <[email protected]> Subject: [Emc-users] flashing with > > mesaflash? > > > > I have installed these file from 5i25.zip, into > > /lib/firmware/hm2/5i25: gene@GO704:/lib/firmware/hm2$ ls -l 5i25 > > total 348 > > -rw-r--r-- 1 root root 340704 Sep 5 2014 5i25_prob_rfx2.bit > > -rw-r--r-- 1 root root 9504 Jan 17 2014 5i25_prob_rfx2.xml > > > > But which is it that I am supposed to write to the 5i25, using > > mesaflash? ISTR its the .xml file but its been a year or so since > > the last time I did it. > > You write .bit files with mesaflash, for a 5I25 you want to make sure > you write bitfiles that have a 5i25_xxxxx.bit file name also > In this case, it looks like prob_rfx2.bit was the correct file. No errors on the --write, or --reload which according to the mesaflash --help screen, can sub for the power cycle.
And I fooled around with pncconf and finally got it to write a config directory. But its too late to test it now. Tomorrow if I get the spindle motor re-installed. Whoever put it together at the factory ought to be fired, the black motor lead that connects to the load side of a back panel fuse holder, was not soldered, only being held against the connector tab by the heat shrink! Unforch, I am not going to have it carving parts by the 7th, when my youngest son is coming in for 2 or 3 days of target practice. The photo-interrupters and limit/home switches are predicted to arrive on the 7th. By then I expect the faster breakout board will have arrived. > The 5I25 manual has an example command line Yes, for a configuration that is not of any great interest or use to me. What I need next is a translator table that converts the module numbers I see in pncconf, to pin numbers on plug 2 of the board. Humm, doesn't dmesg report that? Yes, it did on the lathe, so that will suffice there. And probably far less confusin because its as its seen at fire up LCNC time. I don't think I'd want to consider the complexity of a table that covered all possible options, it might nudify the amazon forest. > > Some install docs in that 5i25.zip sure would be handy. Specifically, where to put ALL the files in it. Thanks Peter. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ Don't Limit Your Business. Reach for the Cloud. GigeNET's Cloud Solutions provide you with the tools and support that you need to offload your IT needs and focus on growing your business. Configured For All Businesses. Start Your Cloud Today. https://www.gigenetcloud.com/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
